[和英文]気体に関する入試類題 2-1          TOP-KISO      

                Japanese-English Exam Similar Question 2-1



 下の問題, 問1 と 問2 に答えなさい。必要ならば, 原子量(すなわち, 相対原子量), H=1.00, O=16.0, および C=12.0 を使用しなさい。


 式 pV = nRT は揮発性液体の相対分子量を決めるのに使用される。

 下の図はこれを決めるのに用いることができる装置を示している。一定量の揮発性液体がガス注入器の中に自動シールのゴムキャップを通して注入され, それから, その注入器は, 注入器中の蒸気の体積が確認される前に, 数分間沸騰水のある浴槽の中で加熱される。1:温度計, 2:ガス注入器, 3:自動シールのゴムキャップ, 4:沸騰水。
                   (image545)
問1

 i 揮発性液体という語句は何を意味するのかを記しなさい。式 pV = nRT の名称を与えて, n と R の記号はこの式中で何を表わしているかを記しなさい。


                             


 Answer the questions below, Q1 and Q2. If necessarily, use the atomic weight (i.e. the relative atomic mass), H=1.00, O=16.0, and C=12.0.


 The equation pV = nRT may be used in the determination of the relative molecular mass of a volatile liquid.

 The diagram above shows the apparatus that could be used in this determination. A known mass of a volatile liquid is injected through the self-sealing rubber cap into the gas syringe, which is then heated in a boiling water bath for several minutes before the volume of the vapour in the syringe is noted. 1:Thermometer, 2:Gas syringe, 3:Self-sealing rubber cap, 4:Boiling water.


Q1

 i State what is meant by the term volatile liquid. Give the name of the equation pV = nRT, and state what the symbols n and R represent in this equation.

                            Answer



 ii 蒸気の体積を読む前に, 数分間沸騰水のある浴槽の中へ入れて置くことが必要であるのは何故かを述べなさい。

                             


 ii Suggest why it is essential to leave the syringe in the boiling water bath for several minutes before reading the volume of the vapour.

                            Answer


 iii 気体分子の挙動に関しての気体分子運動論で作られる 3つの基本的仮定を述べなさい。

                             


 iii State three of the basic assumptions made in kinetic theory of gases regarding the behavior of gaseous molecules.

                            Answer


問2 上に示された装置と同様のものを使用して, 0.167 g のエタノール C2H5OH がガス注入器に注入され, 数分間沸騰水の中に置かれた。大気圧は 101300 Pa で, 浴槽の温度は 100 ℃であった。

 i これらの条件下で形成されたエタノールの蒸気の体積を cm3 で計算しなさい。
  [R = 8.314 J K-1mol-1]

                             


Q2 Using apparatus similar to that shown above, 0.167 g of ethanol, C2H5OH, was injected into a gas syringe and the syringe was then placed in a boiling water bath for several minutes. The atmospheric pressure was 101300 Pa and the temperature of the bath was 100 ℃.

 i Calculate the volume, in cm3, of ethanol vapour that would have been produced under these conditions.
  [R = 8.314 J K-1mol-1]


                            Answer


 ii 容量 100 cm3 のガス注入が適合しないのは何故かを説明しなさい。

                             


 ii Explain why a gas syringe of 100 cm3 capacity was found to be unsuitable.

                            Answer